Author Topic: Change duplex settings on SSG140 ScreenOs6.3  (Read 613 times)

borstel1982

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Change duplex settings on SSG140 ScreenOs6.3
« on: November 09, 2016, 07:44:30 am »
Hi All,

for a provider change I have to change the duplex settings to fixed speed.

I tried to do this using:

Code: [Select]
set interface ethernet0/3 phy full 100mb
I didn't get any error message for this command, but I can't see any changes:

BEFORE:
SSG140-> get int eth0/3
Interface ethernet0/3:
  description ethernet0/3
  number 7, if_info 5656, if_index 0, mode route
  link up, phy-link up/full-duplex, admin status up
  status change:29, last change:11/09/2016 11:43:59
...

SSG140-> set interface ethernet0/3 phy full 100mb

AFTER:
SSG140-> get int eth0/3
Interface ethernet0/3:
  description ethernet0/3
  number 7, if_info 5656, if_index 0, mode route
  link up, phy-link up/full-duplex, admin status up
  status change:31, last change:11/09/2016 14:30:19
...

When I take a look into the "Current System Configuration" in the webUI I can see the following line:

set interface ethernet0/3 phy full 100mb

That's wired. Can anyone explain and/or help?

Thank you in advance! And sorry for my bad english, but I am from Germany :)

Cheers / Regards
Borstel