Author Topic: Show interface 10Gig  (Read 1060 times)

hamdy.rostom

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Show interface 10Gig
« on: January 13, 2016, 06:01:46 am »
Dears,

 when I issued show interface (10Gig), i found the input rate doesn't exceed 9.4Gig however the port is operational in LAN-PHY mode, which as per Juniper it should support up to 10.3G

ueser@Host# run show interfaces xe-1/0/0
Jan 13 01:57:28
Physical interface: xe-1/0/0, Enabled, Physical link is Up
  Interface index: 149, SNMP ifIndex: 566
  Description: #### ####
  Link-level type: Ethernet, MTU: 9192, LAN-PHY mode, Speed: 10Gbps, BPDU Error: None, Loopback: None, Source filtering: Disabled,
  Flow control: Enabled
  Device flags   : Present Running
  Interface flags: SNMP-Traps Internal: 0x4000
  Link flags     : None
  CoS queues     : 8 supported, 8 maximum usable queues
  Current address: cc:e1:7f:01:c9:4a, Hardware address: cc:e1:7f:01:c9:4a
  Last flapped   : 2015-08-17 14:38:18 EET (21w1d 11:19 ago)
  Input rate     : 9448018152 bps (1306731 pps)
  Output rate    : 1441701664 bps (905795 pps)
  Active alarms  : None
  Active defects : None
  PCS statistics                      Seconds
    Bit errors                             0
    Errored blocks                         0
  Interface transmit statistics: Disabled


any recommendations