JuniperForum.com

Networking Platforms => Routers => Topic started by: daniru on February 16, 2016, 09:28:00 am

Title: Allow telnet
Post by: daniru on February 16, 2016, 09:28:00 am
Hello,

I am managing two routers juniper and i need connect with telnet but with the port necessary

The code is the next:

set firewall family inet filter PROTECCION_RE term TELNET-EDC-redundante from source-prefix-list EDC_REDUNDANTE
set firewall family inet filter PROTECCION_RE term TELNET-EDC-redundante from source-prefix-list GESTION_SILAN
set firewall family inet filter PROTECCION_RE term TELNET-EDC-redundante from protocol tcp
set firewall family inet filter PROTECCION_RE term TELNET-EDC-redundante from source-port 23
set firewall family inet filter PROTECCION_RE term TELNET-EDC-redundante from destination-port 1024-65535
set firewall family inet filter PROTECCION_RE term TELNET-EDC-redundante then count TELNET-EDC-redundante
set firewall family inet filter PROTECCION_RE term TELNET-EDC-redundante then accept

Why cant connect with this filter?

Thanks

Title: Re: Allow telnet
Post by: daniru on February 17, 2016, 04:40:13 am
Close