how to configure single policy with multiple networks or hosts

Latest Knowledgebase Articles

How to run the NSM GUI under Mac OS X
How to setup a route-based VPN on a NetScreen
How to make your PPTP VPN client work through a NetScreen/SSG
Setting up a dial-up VPN and NetScreen Remote
How the Global Zone Works (It's probably not what you think)
How to configure NetScreen/SSG devices to work with the built in Mac OS X VPN client
How to Configure Dial-up VPN with route-based tunnels, XAuth, and use IPSecuritas

JuniperForum.com > Networking Platforms > Configuration Examples and Tutorials > Topic: how to configure single policy with multiple networks or hosts

Pages: [1]

« previous next »

Author

Topic: how to configure single policy with multiple networks or hosts (Read 764 times)

JumpinJuniper

Newbie

Posts: 1

how to configure single policy with multiple networks or hosts

« on: August 03, 2009, 11:28:34 PM »

Could anyone enlighten me as to how to configure single policy with multiple networks or hosts? The only way I have been able to do this is to create separate policies on my side for each network and that simply is a PAIN.

Thank you


	Logged

techloh

Newbie

Posts: 3

Re: how to configure single policy with multiple networks or hosts

« Reply #1 on: August 27, 2009, 12:35:40 AM »

You can create a new member list and join related member into a related group.
Object -> Address -> List -> Zone -> New
Object -> Address -> Group -> New

Then you can create a policy with Multiple Source/Destination Address already.


	Logged

crawlord

Newbie

Posts: 8

Re: how to configure single policy with multiple networks or hosts

« Reply #2 on: April 27, 2010, 10:05:06 AM »

set group address "XXX"

set address "VVV" address 192.x.x.x/24
set address "TTT" address 192.y.y.y/24
set address "XXX" address 192.x.x.x/24
set address "XXX" address 192.p.p.p/24

set group address "XXX" add "VVV"
set group address "XXX" add "TTT"

rinse and repeat

then create a bidirectional policy with the group address !!!!


	Logged

Pages: [1]

JuniperForum.com > Networking Platforms > Configuration Examples and Tutorials > Topic: how to configure single policy with multiple networks or hosts

« previous next »