using an ssg320 as a firewall to separate vlans in a cisco witched network.

JuniperForum.com

July 29, 2010, 07:52:01 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

News: If you have an interesting idea for an article or knowledgebase entry, please submit it!

Home

Help

Latest Knowledgebase Articles

How to run the NSM GUI under Mac OS X
How to setup a route-based VPN on a NetScreen
How to make your PPTP VPN client work through a NetScreen/SSG
Setting up a dial-up VPN and NetScreen Remote
How the Global Zone Works (It's probably not what you think)
How to configure NetScreen/SSG devices to work with the built in Mac OS X VPN client
How to Configure Dial-up VPN with route-based tunnels, XAuth, and use IPSecuritas

JuniperForum.com > Networking Platforms > Configuration Examples and Tutorials > Topic: using an ssg320 as a firewall to separate vlans in a cisco witched network.

Pages: [1]

« previous next »

Author

Topic: using an ssg320 as a firewall to separate vlans in a cisco witched network. (Read 1258 times)

bstafford51

Newbie

Posts: 4

using an ssg320 as a firewall to separate vlans in a cisco witched network.

« on: October 27, 2008, 03:06:28 PM »

I have a new ssg320m that will be a firewall between trusted and untrused vlans. Both vlans are in a Cisco switched environment (6509s and 3750). prior to installing the ssg320 I could ping any and all ip addresses including the corporate subnet. The firewall is now wide open. I can still ping all addresses from the untrusted (cisco switched) side of the firewall but cannot from the trusted (ssg320m) side unless I put a default gateway on each switch I want to ping. I need information on the correct way to configure the cisco and juniper equipment so the cisco will properly route.
Note: when I repalce the ssg320 with a cisco router all works as it should , or at least as I want it to.


	Logged

bstafford51

Newbie

Posts: 4

Re: using an ssg320 as a firewall to separate vlans in a cisco witched network.

« Reply #1 on: October 29, 2008, 07:36:47 AM »

problem solved


	Logged

mn_8921

Newbie

Posts: 1

Re: using an ssg320 as a firewall to separate vlans in a cisco witched network.

« Reply #2 on: October 07, 2009, 06:53:08 AM »

ok,but how?


	Logged

bstafford51

Newbie

Posts: 4

Re: using an ssg320 as a firewall to separate vlans in a cisco witched network.

« Reply #3 on: October 07, 2009, 07:23:26 AM »

We said the hell with it and used Cisco router.


	Logged

ajc

Newbie

Posts: 6

Re: using an ssg320 as a firewall to separate vlans in a cisco witched network.

« Reply #4 on: October 07, 2009, 08:12:04 AM »

way to step up to the challenge


	Logged

bstafford51

Newbie

Posts: 4

Re: using an ssg320 as a firewall to separate vlans in a cisco witched network.

« Reply #5 on: October 07, 2009, 08:14:02 AM »

doing more with less does not give time to mess with challenges. If it don't work - move on to what does.


	Logged

Pages: [1]

JuniperForum.com > Networking Platforms > Configuration Examples and Tutorials > Topic: using an ssg320 as a firewall to separate vlans in a cisco witched network.

« previous next »