Howto: Easy route-based VPN configuration

Latest Knowledgebase Articles

How to run the NSM GUI under Mac OS X
How to setup a route-based VPN on a NetScreen
How to make your PPTP VPN client work through a NetScreen/SSG
Setting up a dial-up VPN and NetScreen Remote
How the Global Zone Works (It's probably not what you think)
How to configure NetScreen/SSG devices to work with the built in Mac OS X VPN client
How to Configure Dial-up VPN with route-based tunnels, XAuth, and use IPSecuritas

JuniperForum.com > Security > Configuration Examples and Tutorials > Topic: Howto: Easy route-based VPN configuration

Pages: 1 [2]

« previous next »

Author

Topic: Howto: Easy route-based VPN configuration (Read 17446 times)

Dododope

Newbie

Posts: 46

Re: Howto: Easy route-based VPN configuration

« Reply #20 on: December 01, 2008, 10:09:43 AM »

A little remark is that when you're using the VPN one way only (From site A to site B) VPN Monitor should be turned off. For some reason when it's on my route towards my tunnel.1 interface doesn't become active.

Also I would suggest using different proposals for your phase1 and phase2 to be even more secure..


	Logged

JNCIA-FWV, JNCIS-FWV

shashank

Newbie

Posts: 4

Re: Howto: Easy route-based VPN configuration

« Reply #21 on: May 19, 2009, 11:40:21 PM »

does any one have idea about Auto Connect VPN Configuration


	Logged

anhnh1977

Newbie

Posts: 2

Re: Howto: Easy route-based VPN configuration

« Reply #22 on: July 01, 2009, 07:36:32 AM »

Good night signal15,

May you help me for the Netscreen Remote VPN client to SSG using route-based VPN.
I have try Juniper "Volume 5: Virtual Private Networks" but I am failured

Thank you,