Author Topic: GRE Tunnel Configuration  (Read 2295 times)


  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
GRE Tunnel Configuration
« on: November 08, 2011, 04:26:18 am »
Hello if anybody knows how to configure GRE Tunnel only between SSG5 and Cisco router. please send the configuration for GRE tunnel. i dont want GRE over IPSec i need only GRE tunnel because its in my local network so i dont want to use ipsec.



  • Global Moderator
  • Atomic Playboy
  • *****
  • Posts: 1315
  • Karma: +1/-0
    • View Profile
Re: GRE Tunnel Configuration
« Reply #1 on: November 08, 2011, 06:07:16 am »
I would think (without trying) it should be something like this

set interface tunnel.2 ip x.x.x.x/30
set interface tunnel.2 tunnel encap gre
set interface tunnel.2 tunnel local-if trust dst-ip

With the tunnel on the cisco
abd then ofcourse a route to the destination with tunnel.2 as gateway.

I read somewhere in releasenotes the tunnel interface should be in the same zone as the endpoint interface, but can;t remember the details.
Regards, Screenie