How to clear "show chassis alarms" output?

Latest Knowledgebase Articles

How to run the NSM GUI under Mac OS X
How to setup a route-based VPN on a NetScreen
How to make your PPTP VPN client work through a NetScreen/SSG
Setting up a dial-up VPN and NetScreen Remote
How the Global Zone Works (It's probably not what you think)
How to configure NetScreen/SSG devices to work with the built in Mac OS X VPN client
How to Configure Dial-up VPN with route-based tunnels, XAuth, and use IPSecuritas

JuniperForum.com > Networking Platforms > Routers > Topic: How to clear "show chassis alarms" output?

Pages: [1]

« previous next »

Author

Topic: How to clear "show chassis alarms" output? (Read 491 times)

m4rtin

Newbie

Posts: 4

How to clear "show chassis alarms" output?

« on: February 17, 2010, 02:39:33 AM »

We have a M10i with JUNOS Base OS boot [8.3R1.5]. The problem is, that if there are some issues with PSU or something similar, show chassis alarms indicates those problems, but the alarms still stay there after the problem is resolved. Is it possible to reset show chassis alarms output? With killing alarmd or chassisd output from shell? Does it affect anything else? rolleyes